RFQ/BOM 0 Iniciar sesión / Registro

Selecciona tu ubicación

imagen de usuario

Can anyone help me see where the problem is with the tracking car I made?

Technology
agosto 21, 2020 by Jagger 1615

This is the schematic diagram and PCB diagram of the tracing car I drew. When using Proteus simulation, the motor can run normally, but the motor does not rotate after the board is welded and the components are printed. Who knows the problem? The motor used in welding is a DC motor.

todos los comentarios

user image

Saskia Publicado en August 21, 2020

There is a problem with the power supply of the two chips.

0
user image

Jacobi Publicado en August 21, 2020

Use a multimeter to check if your circuit is normal.

0
  • Jagger

    Jagger Publicado en August 21, 2020

    I tested it after soldering. Only the voltage at JP3 power supply and SW1 is 9.8V, and the voltage measured under other components is 0. Why?

  • Necesitas iniciar sesión para responder. Iniciar sesión | Registro

user image

Willem Publicado en August 21, 2020

Shorten the wire distance of the PCB backplane, try to minimize it.

0

Escribe una respuesta

Necesitas iniciar sesión para responder. Iniciar sesión | Registro