Hello everyone, I would like to ask a few questions below:
Problem description: The core module (EMS6802) + the original configuration backplane, can communicate normally;
The core module (EMS6802) + the backplane made by yourself, can not communicate normally;
The problem is: when using its own backplane, the core module's sending and receiving IO ports have no signals. When using the original configuration of the backplane, both the sending and receiving IO ports have signals;
The schematic diagram of the can port is shown in the picture:
Nolan Publicado en July 24, 2020
First check whether the core board is working properly, and then check whether there is any problem with the wiring sequence.
Melanie Publicado en July 24, 2020
Have you checked whether there is any problem with the board interface you made?
Lydia Publicado en July 24, 2020
After checking, there is no problem with logic or anything.
Brody Publicado en July 24, 2020
Does the main chip of the backplane configured by yourself have the function of CAN controller.
