Recently, a project based on STM32f103 has been uploaded to stm32f051, and now it can be compiled and downloaded to the development board. That is, when the hardware is simulated in the development board, clicking the RUN program does not reflect and does not run. However, it can be executed by single step execution, please give some advice from experts.
Katheryn Publicado en December 10, 2020
Under clean, under compile, look at the startup assembly file, right?
Salman Publicado en December 10, 2020
Can be executed in a single step, indicating that the program should be no problem.
Morris Publicado en December 10, 2020
The setting of the IDE is a problem. Allow it to run after downloading.
