According to the curve of each frequency band measured by the circuit in the figure, there will be a spike at 10HZ and 100HZ. Why is this affected? And the bandwidth in the 100K and 1M frequency bands is not enough. I don’t know what is going on?
Asha Publicado en August 24, 2020
Adjust R43, C30, C28, the value can change the passband, it will be possible.
Maja Publicado en August 24, 2020
The figure below is my high frequency value:
Bodhi Publicado en August 24, 2020
Continue to adjust the value again, will achieve the goal.
Shreya Publicado en August 24, 2020
To widen the high frequency bandwidth, the rcl resonant circuit and frequency need to be adjusted appropriately.
