I made a few 5730LED lighting, the LED voltage is 3V-3.6V / 150MA, my power supply voltage is 5V,
So I got a 12R/1W resistor, and later found it was too hot, so I replaced it with 20R/1W, which was still very hot, about 40 degrees.
If it takes a long time, is it safe?
Orlando Publicado en December 14, 2020
Calculated by power, it must be enough, and 40 degrees is okay.
Carl Publicado en December 14, 2020
If it is made into a board, I plan to use a 1/2W 1812 resistor, or a 1/3W 1210 resistor, which is considered acceptable, but now I test it, even 1W is so hot, I don’t know if the patch is not good.
Helena Publicado en December 14, 2020
You might as well put a few diodes in series or use Zener diodes for transition.
Fernanda Publicado en December 14, 2020
It is better to use two 12 ohms in series, or two resistors in parallel, so that the heat can be shared between the two resistors, and the temperature will be lower. The above is just a personal suggestion! I don't know if it is suitable
