RFQ/BOM 0 Iniciar sesión / Registro

Selecciona tu ubicación

imagen de usuario

How to detect relay plus diode?

Hardware design
octubre 27, 2020 by Kennedy 1466

As shown in the figure, this is a relay found in parallel with a diode. On the PCB board, how to measure D3 with an instrument?

todos los comentarios

user image

Caitlin Publicado en October 27, 2020

Use a pointer type multimeter to resist X1 gear, and both ends of the primary relay winding for each quantity in the forward and reverse directions. The difference in the resistance value measured twice is the existence of D3.

When the red test pen of the analog multimeter is connected to 12V, the measured resistance is small, and the D3 direction is correct.

0
user image

Callum Publicado en October 27, 2020

Divide it twice, add a current-limiting 12V DC voltage from both ends, and then measure the voltage drop. If the voltage is equal, D3 is broken, if one is large, the other is normal. If it is 12V, or 0V, the relay and D3 are both broken

0
user image

Brady Publicado en October 27, 2020

Regardless of whether the relay winding is tested in the forward or reverse direction, it is the same, but if a diode is connected in parallel, the forward and reverse directions are different.

0

Escribe una respuesta

Necesitas iniciar sesión para responder. Iniciar sesión | Registro